New Member

[BERTZR1]

The site looks pretty good,I see A few names I recognize from
corvette forum.

Hello to all.



:chevy: :chevy:

[DavisZR1]

Welcome aboard! This is a great site, and I find it better than most for tech info and good people. Bring some more on board.:cheers: ;bt :usaribbon :chevy:

[UtahZR1]

Glad you found us!:cheers:

[z06joe]

Welcome King ZR1!:bowdown: Although I'm Z06er, we will all have fun and get along here.

[vincec5]

We don't have too many ZR1 members here, it would be great if you can bring some friends along. We would love to here about your mods, see pics and know a little bit more about the KING.:wave:

[BERTZR1]

Well Vince the king happens to be A 1991 White/Gray 415 CID.
Short block was just done Bill Kirchhofer,the heads,plenum,
and injector housings all hand ported by me.Chip is done by Jeff Debuhr.It also has 63mm throttle body,and fresh air intake
made by me.
The brakes are fitted with Wilwood 6 piston calipers set-up
the rears are stock for now.I just recently installed the ZEX
nitrous set-up as well 75-125 shot. that's all it needs right
now.
I had the car on the Dyno last week and the king put down
491 RWHP and 476 RWTRQ on A base program.It still has
A little more in her.All this on stock cams and valves.
The plenum,injector housings and cam covers are powder
coated choice white.You can check it out at my site let me know
what you think.
Http://alzr1.home.comcast.net








:chevy: :chevy:

[vincec5]

The pics and the car look great. Did you go over on the block any? Your shop looks great. Where is your shop located?

Thanks for the info. It's great to have someone with your ZR1 knowledge on board. I'm sure you'll have some people asking you questions.;bt

[BERTZR1]

actually Vince the garage you see belongs to my friend PeteZR1
Were located in Des Plaines just out side of Chicago.My Shop is
located in Des Plaines as well.


Thanks for the compliments.







:chevy: :chevy: